Reply to thread

Message: <blockquote data-quote="Red alert" data-source="post: 1087381" data-attributes="member: 414470"><p>So pole is plum east/west see images. Motor set to 35.9 as shown in image. Strange dish elevation is 20 degrees and not 23. Any higher than 20 and i lose all signal. Dish is plumb on motor because i fixed the dish onto the motor before i attached to pole and made sure it follows the centre line of the motor pole. But getting peak signals within centre of arc and excellent signals at 13 east but dont pick anything beyond 33 east. Also 26 east signals very bad.  Does this sound more like the dish elevation problem or the azimuth still not set on true south properly? Any other checks i can do? Also do you think the 90.00 degrees you can see on right of pole matches the bubble location above it? Also took photos of the side of the motor brackets</p></blockquote><p></p>