Reply to thread

Message

<blockquote data-quote="jeallen01" data-source="post: 1088917" data-attributes="member: 176704">I have no problem with the Inverto Black Twin on my Gibby OP 125L but that's got the V-shaped twin feedarm config, whereas your has just a single arm dish - so it seems to me that would mean that the LNB end of the arm is too high as that would cause the LNB to be aimed too low on the dish face.So, have you checked the arm fixings behind &amp; below the dish face to see if they look to be correctly aligned/bolted up? If they are then it would appear that the arm &amp;/or LNB holder was either badly manufactured or slightly bent &quot;upwards&quot; thereafter. I would &quot;favour&quot; the LNB&nbsp; holder as the one on my dish very firmly clamps the LNB at (what appears to be) the &quot;correct angle&quot;.OR,&nbsp; maybe the supplier made up a &quot;bitza&quot; dish &amp; arm set (CH mentioned that the Gibertini supplier in Harlech is known for doing that!) - and included the wrong LNB clamp? Where did you get it from?</blockquote>

[QUOTE="jeallen01, post: 1088917, member: 176704"] I have no problem with the Inverto Black Twin on my Gibby OP 125L but that's got the V-shaped twin feedarm config, whereas your has just a single arm dish - so it seems to me that would mean that the LNB end of the arm is too high as that would cause the LNB to be aimed too low on the dish face. So, have you checked the arm fixings behind & below the dish face to see if they look to be correctly aligned/bolted up? If they are then it would appear that the arm &/or LNB holder was either badly manufactured or slightly bent "upwards" thereafter. I would "favour" the LNB holder as the one on my dish very firmly clamps the LNB at (what appears to be) the "correct angle". OR, maybe the supplier made up a "bitza" dish & arm set (CH mentioned that the Gibertini supplier in Harlech is known for doing that!) - and included the wrong LNB clamp? Where did you get it from? [/QUOTE]

Verification