usb infinity/titanium?phoenix mode freq

nibber

nibber

Member
Joined
May 12, 2004
Messages
7
Reaction score
1
Points
3
Age
56
Hi again,
Blue titanium card arrived today now the fun starts! i have titanium cardprogrammer 1.10, what i forgot to ask is what frequency do i set it to in phoenix mode? 3.58,3.68 or 6.00Mhz?
Regards nibber.
 
rolfw

rolfw

Believe it when I see it Admin.
Staff member
Joined
May 1, 1999
Messages
38,332
Reaction score
1,644
Points
113
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
3.58 should be the setting, don't put the card in until you have started up the Titanium Proger. If you don't have too much luck to start off with, go into , Control Panel, System, Hardware, Device Manager and look at the Com Port, go into advanced and turn off FIFO buffering.
 
nibber

nibber

Member
Joined
May 12, 2004
Messages
7
Reaction score
1
Points
3
Age
56
Hi there
ok thanks time to experiment
i believe i need to erase the card first, is it worth downgrading the card to 1.03?
regards nibber
 
guiri

guiri

Regular Member
Joined
Apr 5, 2004
Messages
189
Reaction score
1
Points
16
My Location
Manchester, UK
For conax, I needed to downgrade to 1.03 (with MR 1.080 and echostar 808), but it does seem to depend on your setup. You could try first with 1.06 and see how it goes. It only takes a few minutes to downgrade and try again.

Regards
 
Top