Reply to thread

Message

<blockquote data-quote="A nonymous" data-source="post: 805660" data-attributes="member: 240839">The Vu+ Uses USALS <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite8" alt=":D" title="Big Grin&nbsp; &nbsp; :D" loading="lazy" data-shortname=":D" />&nbsp; haven't seen an image yet that gives you the choice to use DISEqC 1.2 Commands.It doesn't work the same way as the old 7020si which uses DISEqC 1.2 Commands as USALS doesn't work with Enigma 1 images correctly.You have to go into setup and then service searching.In there you should find tuner setup.Set the the config mode to simple and the mode as positioner.You then have to put the co-ordinates of your dish in and then it should find the sats itself.&nbsp; Likely hood is that you will have to mess with them a little if the motor wasn't setup with USALS in mind.I have added a screenshot from my Gigablue which is almost the same setup as the Vu+ as the OpenMips image takes quite a bit from OpenPli anyway.Nano</blockquote>

[QUOTE="A nonymous, post: 805660, member: 240839"] The Vu+ Uses USALS :D haven't seen an image yet that gives you the choice to use DISEqC 1.2 Commands. It doesn't work the same way as the old 7020si which uses DISEqC 1.2 Commands as USALS doesn't work with Enigma 1 images correctly. You have to go into setup and then service searching. In there you should find tuner setup. Set the the config mode to simple and the mode as positioner. You then have to put the co-ordinates of your dish in and then it should find the sats itself. Likely hood is that you will have to mess with them a little if the motor wasn't setup with USALS in mind. I have added a screenshot from my Gigablue which is almost the same setup as the Vu+ as the OpenMips image takes quite a bit from OpenPli anyway. Nano [/QUOTE]

Verification