Reply to thread

Message

<blockquote data-quote="subman" data-source="post: 1089563" data-attributes="member: 206094">The Waveguide is at a different angle so the LNB has to go left or right it cannot sit straight in line as the chaparral corotor elbow does . Look at the attached picture . Plus the holes dont line up at the flange because the wavguide is out of alignment , One is vert + the other HozSo its down to bolting the LNB onto this elbow and having it go off at a angle and then sealing off the male elbow flange to the male flange on the corotor .Or plan C bolt the LNB straight onto the corotor using 4 mm studs into the base of the LNB then add washers and nuts to under the corotor flange .Or I try to get the old Elbow off the old corotor , If I can get the old elbow off I can use that I have put a request out to all satelite forums for a someone who may have a old duff corotors . Oh yes the O ring that came with the Elbow does fit the SMW LNB . As for making sure the 2 male flanges or water tight I think a thin layer of Non-Acidic silicone sealant then a few wraps of self amalgamating should do the job .</blockquote>

[QUOTE="subman, post: 1089563, member: 206094"] The Waveguide is at a different angle so the LNB has to go left or right it cannot sit straight in line as the chaparral corotor elbow does . Look at the attached picture . Plus the holes dont line up at the flange because the wavguide is out of alignment , One is vert + the other Hoz So its down to bolting the LNB onto this elbow and having it go off at a angle and then sealing off the male elbow flange to the male flange on the corotor . Or plan[B] C [/B]bolt the LNB straight onto the corotor using 4 mm studs into the base of the LNB then add washers and nuts to under the corotor flange . Or I try to get the old Elbow off the old corotor , If I can get the old elbow off I can use that I have put a request out to all satelite forums for a someone who may have a old duff corotors . Oh yes the O ring that came with the Elbow does fit the SMW LNB . As for making sure the 2 male flanges or water tight I think a thin layer of Non-Acidic silicone sealant then a few wraps of self amalgamating should do the job . [/QUOTE]

Verification