Reply to thread

Message

<blockquote data-quote="subman" data-source="post: 1092958" data-attributes="member: 206094">Thanks Ch for the information But I did buy a replacement Corotor from Satfaca so thats on the dish now as for the old one well I think the only thing I can use on that will be both LNBs and the Elbow .Good News the new LNB is working . Just want to check with some of you that may know the colour code of the skew motors .As far as I can remember the motor has 3 wires&nbsp; Red , White + Black Red is your 5 volt supply White is Skew Black is Gnd Can someone confirm this ?As for the Corotor end on the dish I have not adjusted that end yet but what I can tell you is the signal is well up on the original Q has gone up to about 90 were as before it was 86 , Signal has also gone up about the same . Sat used Astra 4 / Sirius 4 on H 12.303 I still have not adjusted the neck on corotor for max Q + Signal so will let you know what I can get out of it .This is with the Ku Lnb bolted straight onto the corotor .&nbsp; Not had a play with C band yet but I will get get Ku sorted first . One thing I can say is the feed is way off the centre of the dish seems to be about 3 inchs above the centre point of the dish I hope to sort this out with the new arms .When all the above is done I will replace the feed arms since I then have a reference point to aim for then . Still looking for the firmware for the Sattlink 7009 meter as mine is 2014 and I think they have brought out 2019 version .My thanks for all the feed back from everyone once its up and running again should any one want any picture reports on fringe reception in the UK let me know . Max is 65-70 East - 55 West .</blockquote>

[QUOTE="subman, post: 1092958, member: 206094"] Thanks [B]Ch [/B]for the information[B] [/B]But I did buy a replacement Corotor from Satfaca so thats on the dish now as for the old one well I think the only thing I can use on that will be both LNBs and the Elbow . Good News the new LNB is working . Just want to check with some of you that may know the colour code of the skew motors . As far as I can remember the motor has 3 wires Red , White + Black Red is your 5 volt supply White is Skew Black is Gnd Can someone confirm this ? As for the Corotor end on the dish I have not adjusted that end yet but what I can tell you is the signal is well up on the original Q has gone up to about 90 were as before it was 86 , Signal has also gone up about the same . Sat used Astra 4 / Sirius 4 on H 12.303 I still have not adjusted the neck on corotor for max Q + Signal so will let you know what I can get out of it .This is with the Ku Lnb bolted straight onto the corotor . Not had a play with C band yet but I will get get Ku sorted first . One thing I can say is the feed is way off the centre of the dish seems to be about 3 inchs above the centre point of the dish I hope to sort this out with the new arms . When all the above is done I will replace the feed arms since I then have a reference point to aim for then . Still looking for the firmware for the Sattlink 7009 meter as mine is 2014 and I think they have brought out 2019 version . My thanks for all the feed back from everyone once its up and running again should any one want any picture reports on [SIZE=4]fringe reception in the UK let me know . Max is 65-70 East - 55 West .[/SIZE] [/QUOTE]

Verification