Reply to thread

Message: <blockquote data-quote="Manikm909" data-source="post: 1114709" data-attributes="member: 415764">plug it into receiver (for power) then nudge it slightly using the east west buttons.once centered on zero, connect up properly - bolt the dish on to motor (dead centre) - bolt motor and dish on to your pole.....(make sure pole is dead level)make sure receiver at this point has correct latitude and longittudeonce up, (not fully tightened) - then choose channel on 1w, so the motor moves a bit to the west, then manually turn the whole assembly on pole, i.e motor (with dish) on the pole until you lock onto 1w - tighten up motor clamp on pole, then get on with your tweaking with dish and motor angles for usalsalways send dish back to 1w when you do your tweaking, then send to east or west again for checking</blockquote>