Recent content by anto@

I apologize for the translation this morning but the phone played a trick on me in the photo below you can see the power of the 2 tp that are received in Italy spot Central which make reception of the BBC mux impossible at my latitude

la porzione di banda che va da 10900 a 11200 circa è occupata da 2 tp con una banda di 95 MHz irradiati dallo spot di mare centrale, di conseguenza lo spot di mare nord è coperto da questo spot questo è quello che vedo dall'itlia del nord -------- the portion of the band that goes from 10900 to...

the values in % must be taken with the same devices because I have the same system with the same dish, lnb, PC, but with 2 different cards I have different values therefore the values expressed in % are not very reliable

I think you're wrong there are too many signal differences between my system (180 double motor laminas) and Marcus' system given that we are both in the same country except that he is about 700 km further south than me and he has results of almost 2 db of mer believe me 2 db is a big difference...

From what I see it seems like there are different spots given that my (laminas 180) results are lower than Marcus (150) despite the fact that we are in the same country even if there are 700 km of difference between the 2 of us towards the south

my scan today meter Rover 900 plus

my rmy laminas 180 disc scan todayeport

multistream OK my 6522

That's right, it's wavy

the Fibo feed inside is wavy like any KU feed today I shot a video that confirms that it is corrugated inside

ok in the next few months I'll try to do some tests for now it's cold and time is short having 1 lnb on the side in the exact position I will be able to make comparisons and find the best point for now I thank you

I think that's where the LNB is!! so the center of the sub will be the center of the LNB cap or am I wrong!!!

I understand your theory but in practice? What measurements should be used? laminas 180

I found this object in a friend's warehouse, and having seen a topic in this section that talks about it, I could install it on my rotor feed. at the moment it has been removed for extraordinary maintenance and is therefore within reach. question? Where should the sub reflector be installed? in...

there are no changes or proposals, it's just a matter of wanting to activate the systems in T2 since they are already ready, the first tests in T 2 date back to 2012 with 2 Mux irradiated for some time then they were deactivated, all that is needed is the will to do it since broadcasters fear...