Recent content by Birdseeker

Thank you so much Victor.

Thank you very much. Could you find out how much does it cost to Australia?

Thank you .

Sound good if you are able to get one at this price and lived in the Euro zone. However, if you are at the other continent, it will be cheaper to find the alternative replacement. Getting the Lcd that will fix the older Satlook Micro is a pain because the company no longer making it. Therefore...

On the X-Pol selection, are you looking at highest H signal and lowest V when on 18V setting and vice verse when 13V for X-Pol isolation?

The original LCD was discontinue and no longer available. I was wonder anyone used the alternative that worked?

Hi I had play around with the metre, my G2 does not has the db reading but it has gain function, it read 0.97 t 1.0. I am not too sure is the gain same as the db you refering to. Thank you Rolfw

DEar Rolfw Thank you very much for helping me. So polarisation isolation is simply maximise the peak on the spectrum.

Hi Rolfw Can you give me some helps how to read the spectrum for cross polarisation 1. How do I read the peak for whether the V and H are cross on the spectrum? 2. Do I look at the maximum peak of H when swith to 18V and maximum signal strength of V when it was on 13V for skewing the LNB? 3...

Thank you Robbo. I only has the 36 V motor. I wish somebody in this forum who are good at the meter do a video clip, that wil be handy.

Hi, Thank you very much. I had see the text yesterday, thank you very much. I tried he 36V actuator yesterday but must connected via the V-box to do that, it can move the disk and the positionf untion also worked fine. However, the Go to X has not work for me on 36V motor.

Can you explain this section in detail please such as how do you connect the meter to the disk, do you need the help of the receicever tha connected to the actuator? Thank you

Hi Crossbones Did you connected the satlook through the receiver inorder to move the motor? :confused:

Thank you very much.

Thank you very much.