Recent content by cocker80

Cheers, will look into it before rushing in ;0)

I have got a longer pole and a spare T bracket (not k as previously mentioned) so will move the bottom k bracket futher down and put the T bracket where the K bracket was.

Cheers, I have got a spare K bracket so will also use that. I will have a crack at it at the weekend and will post the results.

I won this dish of ebay for £20, bargain :cool: Currently I have it set to 7west and getting good results. My intention is to replace my motorised 1m orbital dish so I brought a Moteck h180 motor and a Vbox, my orbital dish is on T&K brackets do you think that will be enough to support the...

Getting nothing of them 3 transponders, but still getting the ones i previously mentioned. Will give it another go later.

Just picked these channels up... 12575V 3000 - Majd1 12611V 2580 - ERITV CH2 Looking at flysat they look like they are comming from Arabsat-5A, is anyone else seeing them?

Picking up a picture on 12034v using a 1m dish in the midlands :)

Yep the image is from the manual that came with my 2300, but should be the same as the 2600. There is a screw on the sliders that allows you to lock them into place. I can scan the manual and upload it if you require it?

Think the attached image is what you are after. Better late then never ;0)

At the moment only getting 12034V 12245 H

Is there a free channel editor that will allow you to use 13 favourites, I have tried setedit 1.01 from fortec but it messes everything up as it only uses 7 favourites. At the moment I am abit skint so cannot afford the 1.03 upgrade, so is there any other free editors available?

Using a 1m orbital dish with a inverto black ultra lnb in Stoke-on-Trent i can get 11996V, 12014H, 12034V, 12054H, 12073V,12245H with about 45%-53% signal quality

Just brought on of these packages for my mum’s house, I could not resist cracking the top of the receiver. The marking on the chip don’t match any of the sl35/65 I know of. NXP CX24301-13AZ FOG163.1 K-G0920b MpegII Decoder ARM Sorry for the bad picture.

I’ll give that a go Satelliteman. Every now and again I have to re-align, I can only assume that the weight of the dish is moving it slightly on the motor.

I did not use the elevation scale on my dish because it is totally cocked up. I set my dish use using 12169v 28000 on 1w (CityTV), for me it is a weak transponder but between 7.00am – 9.00am I usually get a good signal. I tweaked the dish position and elevation to match that transponder and I...