Reboot, as step 4 in 1st post then setup as you would normally add - channels & cccam plugin etc.
4: Once the flash progress meter has reached 100%, turn the DB off then on again.
On my DM600s Dreambox edit standard path for Enigma1 is var/tuxbox/config/engima/
var/tuxbox/config/engima/
var/etc/
I used DCC to search these folders and I could not find the folders/paths but scanned channels seemed to been in the engima folders – so I set it to use ‘Version 3 setting...
Just can’t get this to load on my dm600s using image Enigma1 (Pli-jade2-dm600pvr-20090322-6302) DBEdit 3.0.0.0.
I’ve read thought the thread and tied setting 2 ,(I’ve tried them all 3 & 4,) rebooted but the bouquet will not show, just has my original sat scan.
Is it down to the image I’m...
Easiest way to find IP address is in your router.
Log into your router and it will list all connected clients there name, IP & mac addresses.
My dreambox showed up with no name just (blank) an IP address & mac. (mac matched).
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.