Bad luck for me…after install CAS8.6b to new PC with fresh windows XP Pro SP3, same problem still remain.
CAS 3 Hardware can be Diagnostic / firmware update ?
Much Appreciates for your advice.
already uninstall and re-install Cas 8.6b..
Device manager show >>
JUNGO Install
>Win Driver
>Cas Interface 3 USB (only appear when USB connected)
Still with same problem.....keep waiting to start program...
please help
already done..
1. Start Cas Interface Studio 8.6b.
(display show >> Pelase Connect the device in your USB Port)
2.Connect CAS3 to USB Port.
(display show >> CAS Interface 3 Connected.Waiting to start program......)
............go on waiting to start program.
Currently i'm using WINDOWS XP Pro.
When I try to run cas3 with cis8.6b programmed I just get a screen pic with "waiting to start programmed..." programmed does not start.
I have done restart pc
then run CIS 8.6B and plug cas3 into usb.
Already follow readme procedures but still with same...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.