Replaced my old motor yesterday which had been up for eight years before giving up the ghost. Everything tight!
The old one did quite well when I think of all the high winds that it endured over the years, and never got blown off course once.
January is always a good month for wind. I find if...
Well I finally got a roundtuit on the bank holiday Monday while the rest of you were at the Royal BBQ.
I housed the switch in an IP66 box (bit of a tight fit) and connected all up and I am pleased to say that it works seamlessly.
Regards,
Yorks.
Yes, as you say the only way to find out is to try it.
I've ordered the SPS, so we'll see. I might wait until it get's a bit warmer though, before I give it a go. :-rock
Thanks for the reply Huevos.
Yes I think the DiSEqC command order from the receiver should be ok. In my current set up, I have a single receiver connected to 2 motorised dishes via a 2/1 DiSEqC switch. One dish covering 53E to 8W, the other dish covering 12W to 45W. The receiver switches...
I have connected both receivers to the motor via a manual A/B switch and both drive the motor when switched. I have tested using DiSEqC 1.2 and USALS. Both protocols worked fine! :-
Lounge test
Connected both receivers to motor using manual A/B switch.
Connected both receivers to separate...
In your OP you mentioned a twin lnb. Where does the 2nd lnb connect, or are you only using one feed from it. (Is it time I was making my way back before they notice I'm awol?!)
I think I will connect both receivers to a motor via an old a/b switch in the comfort of the lounge, just to see if...
Hi T_G,
Interesting. I take it you have one of the twin lnbs bypassing the motor?
As the receivers are going to be quite a distance apart, loop-through is not really practical.
Thanks for the reply Paul.
Would it "know" if using USALS maybe?
Thanks, yes the NHS shake-up means that they've removed the guard from the door. Just need to be back before lights out.
It's been a while since my last installation and I want to change things a bit :-ohcrap:-
I want to connect 2 receivers (one will be upstairs) to my motorised dish and both receivers also to a fixed dish.
I don't need to use/view the motorised dish from both receivers at the same time - so a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.