Ordered A Cas Plus Programmer

[digimac_uk]

and am hoping to update my magic module to matrix reloaded for D+ and tv cabo on Hispasat. Is it straight forward? Is Cor around to give any advice as he seems to a a bit of experiance in this, can anyone point me in the right direction before I bu**er up a perfect good cam ( Vers 104 Penta 1.11)?
Cheers

 

[>COR<]

Hello M8,

Using the normal cas interface and programmer card that comes with it.

The procedure for that one is a simple one delete the old firmware using delete all button, wait till all 34 blocks are erased.
Then select the file to write, i.e. now the MR1.055, select it and then click write.

The cas + interface just works with studio 2.1, and the programmercard is replaced by the pcmcia interface.
After programming pull the cam from the slot, and plug in again, wait 15 seconds then the cam will initialise in the programmer.

Put the cam in the reciever, and it should work straight away m8.

Just needs to update the key's so the first time it can take 1 or 2 minutes on D+ to update.

Cheers,

Cor.

 

[digimac_uk]

Champion, just champion

 

[digimac_uk]

I got it working!!!! Cheers Cor!!!!!

 

[Recifor]

First at all I beg pardon for my English I'm Spanish, and I'm looking for the correct Volts and polarity I should feed the programer.
Any one nows a Web with explanations?
Many thanks

 

[rolfw]

All of the information is on the www.duolabs.com website.

 

[Recifor]

All of the information is on the www.duolabs.com website.

I got all the information needed in this Web and in Spanish lenguage and current needed
Gracias
O-Ha

 

[digimac_uk]

the cas programmer was not recognised until it was given 9 volts dc.

 

[Recifor]

I try diferent voltages, in 9 V no good, 12 V. no good I try 7.5 V. and all Ok.
Many thanks