nadal liu
Regular Member
- Joined
- Jan 16, 2014
- Messages
- 38
- Reaction score
- 3
- Points
- 8
- My Satellite Setup
-
120cm offset dishes for 124e and 128e with emp centauri profi multiswitch 9x16, and 5x20
,180cm prime dish with lo 10678 ku lnb for 110e bs/cs
- My Location
- Hong Kong
Hi, I am the op here and it is an old thread.
Basically I asked questions on if I could use a ms and Quattro lnb on a Japanese satellite systems.
I finally got a chance to ask a friend to test.
It was a success except that he said on certain channels he saw some scrambles.
He then researched and found out that these channels were on tp 12733.
As the frequency is high he suspects that it is too high for a receiver to handle.
A Japanese receiver operates in the range of 950-2150 mhz.
Given the frequency being 12733, 12733-10600 gives 2133mhz.
He suspects that it is too close to the upper limit of 2150.
My questions to you are if you have some channels on or above the frequency of 12733 and if you have issues with these channels using the Lnb with Lo of 10600.
We normally use 11200 or 11300 lnb on a Japanese satellite.
Thanks.
Basically I asked questions on if I could use a ms and Quattro lnb on a Japanese satellite systems.
I finally got a chance to ask a friend to test.
It was a success except that he said on certain channels he saw some scrambles.
He then researched and found out that these channels were on tp 12733.
As the frequency is high he suspects that it is too high for a receiver to handle.
A Japanese receiver operates in the range of 950-2150 mhz.
Given the frequency being 12733, 12733-10600 gives 2133mhz.
He suspects that it is too close to the upper limit of 2150.
My questions to you are if you have some channels on or above the frequency of 12733 and if you have issues with these channels using the Lnb with Lo of 10600.
We normally use 11200 or 11300 lnb on a Japanese satellite.
Thanks.
