I've been using an EZ-2150 positioner with my Dreambox for several years to drive my 1m dish. I replaced the Superjack actuator about 6 months ago & all was fine. The v-Box suddenly produced the nP error complaining that it couldn't sense pulses from the dish.
I checked the conections at the dish and all seems fine. If I stick a voltmeter across the motor connection at the back of the positioner and attempt to move the dish using the V-box buttons I was expecting a jump to around 36v before the nP error cuts it off but the reading is way below that.
Are there any tests I can carry out to check if the V-box has failed?
I checked the conections at the dish and all seems fine. If I stick a voltmeter across the motor connection at the back of the positioner and attempt to move the dish using the V-box buttons I was expecting a jump to around 36v before the nP error cuts it off but the reading is way below that.
Are there any tests I can carry out to check if the V-box has failed?